Shoe Size Guide

Sizing varies across the range of Bont Cycling shoes with both European and US listed for comparison. Download the Bont Cycling Shoe Tracing Grid and easily measure the length and width of both feet using our A4 PDF. Instructions for measuring can be found below.

The tracing grid also allows customers to determine if they may need semi or full custom shoes. Foot tracings demonstrate the areas where additional space or varied shaping is required and allows our custom team to assess the best size, width and style of shoe for your feet.  

Our Size Wizard and Sizing Chart will also assist in finding the correct size and width shoe for your feet for those with more general sizing needs.

Keep in mind the lengths listed on the sizing chart are the actual length of shoe last. Unless you like your shoes extremely tight (you don't), add 5-7mm onto your foot length measurement to get the right size shoe. Bont Cycling shoes vary in size by 5mm so it's important to measure your left and right foot length and width as accurately as possible.

Hit the Contact Us button at the bottom of this page with any questions around sizing.

How to trace your feet

1. Download the A4 Bont Cycling Tracing Grid and print with zero scaling. Check the dimensions and you're good to start the tracing process.

2. Take your shoes and socks off and stand with your left foot directly on the page. Keep your foot as close to the left and bottom edges as possible unless your foot is too large to fit on the paper. If so, place your foot diagonally across the page as shown in the image below.

3. Take a thin black pen and hold it in a vertical position. Begin to trace around the entirety of the foot while ensuring you do not make the tracing smaller or larger than your foot length and width. You should be standing upright position on both legs with load weighted onto the forefoot (front of foot). This step is best performed with an assistance or helper but it can be done yourself if required. 

4. Remove your foot and repeat the tracing with your right foot. 

5. Take a ruler or accurate tape measure and note the length and width of both feet. Mark the longest and widest point of each foot at all four side and draw a straight line across each section to demonstrate where the measurement is taken. Write length and width of both feet in the area allocated.

6. Scan and email or fax the tracing complete with contact details to Bont Cycling for all sizing, semi and full custom enquiries. Ensure all relevant details are outlined in your enquiry including issues with current cycling shoes and areas of the foot needed particular attention.