Front Bumper - Vented

Front Bumper - Vented

US$10.00
(1 review) Write a Review
SKU:
NPFB-S
Other colors available

Please note that Double Wide shoes are a special order item. These are not eligible for return. Click here to view our full returns policy.

Adding to cart… The item has been added

The Front Bumper Road kit is a replacement item suitable for the latest models from Bont Cycling and is limited to Zero+, Helix, Vaypor S, Vaypor+, Blitz, Riot+ and Riot buckle.

Maintenance tips

Use a small amount of acetone or nail polish remover to dissolve any glue from the base of the shoe. Try, as best as possible, to apply the acetone right where it is needed. If necessary, pry the toe guards off the sole slightly to apply the acetone onto the underside.

Each kit contains left and right bumpers and can be installed on the models above using Loctite 401 or equivalent.

How to: Remove and Install Front Bumpers

Sizes available

  • Small (size 36 - 40.5)
  • Medium (size 41 - 44.5)
  • Large (size 45 - 50)

1 Review

  • 5
    Front bumper replacement

    Posted by Adam on 5th Jan 2023

    Great service and advice from Bont.Couldnt do enough to help me.

IMPORTANT

Be advised all measurements shown in the size charts above are listed in millimetres and refer to all current models purchased after 2015.

NEW SIZING METHOD

To find your Bont Cycling shoe size, download and print our all-new sizing page in A4 or Letter and follow the instructions exactly as listed. Mark with a straight edge your longest toe and widest part of your foot. Double check the length and width with a ruler to confirm your measurements. Be advised, this is a newly developed sizing page so please send any feedback to our team by clicking the red 'speech bubble' in the corner of the page.

ORIGINAL

To find your size, place a piece of paper on a flat surface and place it directly up against a wall. Stand on the paper and ensure you have a 1mm gap between your heel and the wall. Plant your foot firmly on the ground and slowly roll your weight forward and onto the forefoot. For the most effective longest toe measurement, your heel should lift off the ground slight. Look down and take the measurement from the wall edge of the paper to your longest toe. Record the length. With your foot still in place, mark the widest points of the inner and outer edges of your feet. Measure the width across the widest part of your foot and record the number in millimeters. Repeat this step for both feet.

Once the measurements have been taken, use the Foot Length Range on the size chart to find your size. The Last Length measurements shown on the chart are the exact length of the last that we use to build the shoes. This correlates to the precise internal measurement of the shoe.

Following selection of your size in EU or USA, move downward to select the most appropriate width. We recommend adding 1mm to find the most appropriate width. For example, you are looking at a Vaypor S and have determined your best shoe size is 45 and your feet measure 105mm (left) and 107mm (right) wide, with an additional 1mm added, you would still fit within the Standard Range. If your feet measure wide than 109/110mm (size 45/10.5) you should consider Wide fit.

NOTE: The stated size width range does not reflect the actual width of the shoe. Bont Cycling shoes are designed with structural support throughout the entire length including the forefoot and as such, the measured shoe width is designed to appropriately support the foot within the shoe. The width of the shoe will almost always be narrower than your foot which is intentional in order to provide the necessary support.

Please also keep in mind Bont Cycling shoes are designed around an anatomically correct last suitable for cycling however, this does not mean they are built in the 'bare foot' running shoe style.

For sizes that fall outside of our size chart, please get in touch HERE.